Temperature Tuning Issue.

Discussion in 'Troubleshooting' started by Robert Cordero, Mar 19, 2021.

  1. Robert Cordero

    Mar 10, 2021
    Likes Received:

    I been having a hell of a hard time with a Hemera upgrade on my Ender 3 V2. I am completely lost. i tried to run the Temp test from Teaching Tech. and below is what i get. i have gone through all of their calibration test and not one has worked correctly. Any help?

    Bed: 60 deg C
    Segement E: 225 deg C
    Segement D: 215 deg C
    Segement C: 205 deg C
    Segement B: 195 deg C
    Segement A: 185 deg C
    First Layer: 200 deg C

    Part Cooling: 100% fan from layer 2

    ABL: Probe new mesh at the start of print - G29 (BLtouch,EZABL,etc)

    Retraction distance: 0.6 mm
    Retraction speed: 40 mm/sec

    Attached Files:

Share This Page