The E3D-V6 collet is popping out

Discussion in 'E3D-v6 and Lite6' started by Vasco Reis, Oct 21, 2016.

  1. Vasco Reis

    Vasco Reis New Member

    Joined:
    Oct 21, 2016
    Messages:
    1
    Likes Received:
    0
    Hello

    I searched the internet but ... no solution. The collet of my E3D-V6 is popping out which causes the PTFE tube to move and consequently the extruder clogs.
    Anyone know how can I solve this problem?
    Thank you
     
  2. Greg Holloway

    Greg Holloway Administrator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    565
    Likes Received:
    397
    Lift and hold the collect up and then push the PTFE down. That should lock it in place.
     

Share This Page