Thermistor Reading 10ºC cooler

Discussion in 'E3D-v6 and Lite6' started by berniek, Apr 8, 2015.

  1. berniek

    berniek New Member

    Joined:
    Apr 8, 2015
    Messages:
    1
    Likes Received:
    0
    Just in the process of installing the V6 in my Mendel 90, and after changing the thermistor table to 5, now I'm getting the thermistor reading 10 degress cooler, and hovering around the mintemp, so it won't start the hot end.

    Any idea what could be causing this?
     
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    444
    Likes Received:
    89
    Table 1 and 5 are different so it will read different if you were running an epcos to a semitec.

    If it's not getting above mintemp it's either a loose thermistor/faulty heater circuit.
     

Share This Page