Thermistor Wire question

Discussion in 'E3D-v6 and Lite6' started by Drummuz, Sep 11, 2016.

  1. Drummuz

    Drummuz New Member

    Joined:
    Sep 11, 2016
    Messages:
    1
    Likes Received:
    0
    Hi, (sorry for m english)

    I have the e3d lite with the new version of the thermistor. I have a MKS board with different connector than the original e3d,

    So i decide to remove the original one to put an old connector to fit it on my board.

    Everthing is working fine but, Sometime i got ERR:mintemp, i restart my printer and everything is fine.

    I re-check my tin solder and everything is ok ...


    Do you have any tips about soldering,type of wire, etc.

    Thanks
     
  2. Rapier503

    Rapier503 New Member

    Joined:
    Sep 19, 2016
    Messages:
    1
    Likes Received:
    0
    Is there a positive and negative with the thermistor?
     
  3. mike01hu

    mike01hu Well-Known Member

    Joined:
    Apr 22, 2014
    Messages:
    957
    Likes Received:
    166
    No, there is no polarity for a thermistor.
     

Share This Page