SOLVED tightening x-axis belt titan hybrid

Discussion in 'Build Help' started by kevclarx, Jul 28, 2016.

  1. kevclarx

    kevclarx Active Member

    Joined:
    Jul 8, 2016
    Messages:
    30
    Likes Received:
    4
    Looking at the build guide it says to use a 2.5mm allan wrench right below the y endstop, but my x carriage does not have a hole there that I can see. Looking at the way I put the belt on it almost seems as if I have to somehow get to the grub screws which are vertical.

    NM: found the right hole on the opposite side of the carriage...looks like docs need to be updated for this step.
     
    #1 kevclarx, Jul 28, 2016
    Last edited: Jul 28, 2016

Share This Page