Titan Aero issue

Discussion in 'Titan' started by BMilam, Sep 1, 2017.

  1. BMilam

    BMilam New Member

    Joined:
    Sep 1, 2017
    Messages:
    1
    Likes Received:
    0
    I have 3 Titan Aeros, 1 of them does not have the hole drilled all the way through the center of the front, the 2 new ones I just got have the holes drilled all the way through. Can someone tell me why the difference?

    The reason I am wondering, is the first one (without the hole drilled all the way through), I was not able to use the e3d stepper motor with, it binds up. I had to grind down the shaft to get it to work.

    Thanks
     
  2. Jonas

    Jonas Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    53
    Likes Received:
    29
  3. Antoine

    Antoine Well-Known Member
    Staff Member

    Joined:
    Apr 3, 2017
    Messages:
    47
    Likes Received:
    10
    As you have discovered by yourself, the first version did not allow non E3D stepper motors to run properly if the spacing was not respected. This was fixed by having a hole drilled all the way through for the shaft to have more clearance.
     

Share This Page