Titan Aero not extruding

Discussion in 'Titan' started by utub, Jul 14, 2020.

  1. utub

    utub New Member

    Joined:
    Jul 14, 2020
    Messages:
    1
    Likes Received:
    0
    Hello,

    Recently setup the Titan Aero on my ender 3. I've performed all of the instructions as per the documentation (as well as watching a Teaching Tech vid alongside), only step I haven't done is calculating esteps. However, while I can get up to temperature and push filament through manually, the extruder motor does not seem to push any of the filament at all. Also is difficult for me to pull the filament back out (not sure if this is common or not).

    As far as I'm aware, won't really be able to configure esteps properly unless my motor actually starts pushing filament through unless this happens to be the issue then I would love some instruction on what to do! Also wondering if the ptfe tube that has to be placed within could be causing issues?

    Some relevant info:
    Using the extruder motor the ender 3 came with for the titan aero
    Using a PT1000 temperature sensor with a #define TEMP_SENSOR_0 value set to 1047
    Attempted to use PETG for the first test run

    Any help would be appreciated!
     
  2. Parzival

    Parzival Member

    Joined:
    Aug 29, 2020
    Messages:
    3
    Likes Received:
    0
    Im Having the same issue anyone know?
     

Share This Page