titan aero on cr10s pro v2

Discussion in 'HotEnds & Extruders' started by shua, Dec 19, 2020.

  1. shua

    shua Member

    Joined:
    Dec 18, 2020
    Messages:
    3
    Likes Received:
    0
    got a stock cr10 pro v2 running tinymachines firmware
    i want to upgrade to a titan aero and have all the parts ready to go onto the printer
    i saw i have to change some firmware settings so i looked around and found here is where i can get the .ino file to change them on GitHub - InsanityAutomation/Marlin at CrealityDwin_2.0
    i have downloaded this but still not sure about what steps to take next
    any advice would be greatly appreciated as i have looked all over the internet for how to do this
    what changes will i need to make to this fimware?and is there anything i should know before doing it
    thank you very much
     
  2. shua

    shua Member

    Joined:
    Dec 18, 2020
    Messages:
    3
    Likes Received:
    0
    k so got 2 things im not sure about in the firmware

    first is the cr10 pro v2 abl sensor abl_ubl or able_bi
    and is the bed dc or ac powered
    thanks a lot
     
  3. shua

    shua Member

    Joined:
    Dec 18, 2020
    Messages:
    3
    Likes Received:
    0

Share This Page