Titan Direct Drive on a Flashforge Creator pro

Discussion in 'Titan' started by 20vt, Jan 9, 2018.

  1. 20vt

    20vt New Member

    Joined:
    Jan 9, 2018
    Messages:
    1
    Likes Received:
    0
    Hi all,

    after the conversion to e3d Hotends on my 2 CR-10´s and on the Hypercube build.
    I have build the Titan direct Drive / E3D Lite on my flashforges Creator pros.

    Finally it runs but i have massive problems to find the right extruder settings.

    I changed the S3D Multiplier to 3,80 or someting because i can not change the Firmware.

    Does anybody has an idea how i can set E-steps on the Flashforge proberly?

    I wondered if it´s possible to set it on Start G-Code?


    Thanks in advance
     
  2. dc42

    dc42 Well-Known Member

    Joined:
    Aug 16, 2016
    Messages:
    526
    Likes Received:
    221
    You could try M92 Ennn in your start gcode, where nnn is the steps/mm for your Titan.
     

Share This Page