Titan Extruder In a Bowden Setup On the Ender 3

Discussion in 'HotEnds & Extruders' started by Grimfyre, Jun 6, 2020.

  1. Grimfyre

    Grimfyre Member

    Sep 30, 2018
    Likes Received:
    I have a question for anyone out there that might've used the E3D Titan Extruder in a Bowden set up.

    I've calibrated the E-steps required for the Titan... However I'm trying to dial in the flow rate for fitted parts. I did the flow rate calibration cube and according to the math my flow rate would have to be lowered to something near the 75% range... Is this normal or is something wrong?

    I'm wondering if the flow rate on a titan is much different then the stock extruder?

    Any advice?

Share This Page