Titan firmware for lulzbot taz 3

Discussion in 'Titan' started by m4rtin, Jun 26, 2017.

  1. m4rtin

    m4rtin Member

    Joined:
    Jun 26, 2017
    Messages:
    3
    Likes Received:
    0
    I upgraded my taz 3 to a titan extruder with an e3d hotend, i am having trouble looking for the firmware to flash my taz 3 to run the titan extruder. I currently have a taz 4 that was upgraded to a e3d titan extruder and hotend, but it was purchased that way. All I want to do is copy what I have on my taz 4, any help will be appreciated. Thank You
     
  2. Antoine

    Antoine Well-Known Member
    Staff Member

    Joined:
    Apr 3, 2017
    Messages:
    47
    Likes Received:
    10
  3. m4rtin

    m4rtin Member

    Joined:
    Jun 26, 2017
    Messages:
    3
    Likes Received:
    0
    thanks for the reply, will try to modify the firmware and update. BTW I am not using the titan aero, I am using the original titan extruder.
     
    #3 m4rtin, Jun 27, 2017
    Last edited: Jun 27, 2017
  4. Antoine

    Antoine Well-Known Member
    Staff Member

    Joined:
    Apr 3, 2017
    Messages:
    47
    Likes Received:
    10
    Sorry sorry about that. The steps are the same though. You should find the settings for step/mm in the "configuration.h" file.
     

Share This Page