Titan & V6 not working right

Discussion in 'Titan' started by cozmicray, Sep 1, 2016.

  1. cozmicray

    cozmicray Member

    Joined:
    Mar 1, 2014
    Messages:
    8
    Likes Received:
    0
    E3D Titan and V6 mounted on Folgertech FT-5 not working well.

    Ripped off the provided FT-5 extruder and hotend because of max frustration
    and bad extrusion

    Mounted up Titan and V6 --- extruder even worse now.
    Can't do any thing close to a calibration
    It is a good filament grinder with big pile of ground filament in there.
    Tried all kinds of spring settings, different filament, different step/mm
    can't get good extrusion.
    Hobbed area on drive was too far back --- shimmed it out wit washer
    no help

    Anyone got magic procedure to set it up.

    Dumpster is filling up with used extruders / hotends!!!!
     

Share This Page