Trouble Tuning my super volcano

Discussion in 'HotEnds & Extruders' started by coffeeoutlaw, Oct 3, 2021.

  1. coffeeoutlaw

    coffeeoutlaw New Member

    Joined:
    Oct 3, 2021
    Messages:
    1
    Likes Received:
    0
    i am running the 12 v Svolcano on my ender 3, i hooked up the mosfet as according to instructions, but when i try and pidtune it to 200, th temp over shoots by about 30 degress and the tune fails, any tips on whats going wrong?
     

Share This Page