trouble with titan volcano stripping out on filament

Discussion in 'Troubleshooting' started by dexter minneman, Aug 21, 2019.

  1. dexter minneman

    dexter minneman New Member

    Joined:
    Aug 21, 2019
    Messages:
    1
    Likes Received:
    0
    my prints are starting out great makes a raft very well gets a 10 or so layers into the print and then stops extruding. it always ends up being the extruder stripping out a notch in the filament. any ideas?
     
  2. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,546
    Likes Received:
    481
    Retraction settings ?
     

Share This Page