"Tune" menu in Marlin

Discussion in 'Calibration, Help, and Troubleshooting' started by R Design, Mar 17, 2016.

  1. R Design

    R Design Well-Known Member

    Joined:
    Oct 7, 2015
    Messages:
    944
    Likes Received:
    190
    I've just ventured into the "Tune" menu for the first time.

    1) Why does "Speed" say 100 when max speed in Simplify is 50mm/s ?

    2) Why does "Fan" say 76 when the LCD says 30 and that is the setting in S3D? (yes S3d is set to allow higher speeds if layer time <15 secs, but that's not the case...)

    3) There seems to be a bug because can't edit the "Fan": clicking on it always end up on "Flow";
     
  2. PsyVision

    PsyVision Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    798
    Likes Received:
    248
    1) Because it's a %

    2) Because this is the raw value in the range [0 - 255] therefore 50% fan will show 127. 76 is 30%

    3) This is a known bug. Use the Control menu.
     
    Mike Kelly likes this.
  3. R Design

    R Design Well-Known Member

    Joined:
    Oct 7, 2015
    Messages:
    944
    Likes Received:
    190
    Cool.

    Thanks a lot!
     

Share This Page