two more odd firmware behaviors (Hybrid-dual-titan-mirrored)

Discussion in 'BigBox General Chat' started by Steven, Jun 27, 2016.

  1. Steven

    Steven Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    211
    Likes Received:
    19
    After x,y,z home function, the carriage moves to the ooz bin/dumpster, but crashes into the left corner of the frame cutout.
    It will then move to the center to print.
    But If I hit Stop Print (abort) the X axis motor goes into an oscillating pattern. Can stop that unless i kill power.
    Any one else have this?
     
  2. mike01hu

    mike01hu Well-Known Member

    Joined:
    Apr 22, 2014
    Messages:
    957
    Likes Received:
    167
    It sounds like you have the wrong firmware version loaded, mirrored or normal.
     
  3. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    731
    Likes Received:
    93
    Yes, but I am still on the supplied firmware so that could well be the problem.

    A number of people have reported similar crashes but I'm not sure if they mentioned their level of firmware.

    As I'm posting this message appeared from Mike01hu :)
     

Share This Page