Hello, I've just update my K8200 with a e3D V6 : great product, i can print 2-3 time faster with better quality! but i have a problem since the update : i print PLA on blue tape. the first layer don't stick to blue tape. i've try to play with bed/nose distance, with first layer speed, but i can get the first layer to stick correctly ( no problem with the original hotend with same pla and same temp). as the first layer don't stick i got wraping and/or tall part the go off the bed. what can i do ?
thank you i will try. in the mean time, it's seem to work with drastic change in my configuration: i've greatly reduce the first layer speed and i've see that the bed/nose distance is far more important than before and i must be much much closer than before. i think it's due ti the fact that the flat surface around the nose hole is much smaller