Upgrade issues I upgraded my Solidoodle three's extruder with the E3d v6. I followed everything to the letter including all of the arduino changes. When I starts Repetier host I have full heats and movement abilities for a few seconds then they stop working. The software doesn't settle down I just lose my ability to do anything with it. I compress the disconnects on the software and reconnect and it will work for the same mountain of time and then shut off to do anything with it. I compress the disconnects on the software and reconnect and it will work for the salmon mount of time and then it eill stop again.it's driving me nuts. Could it be my power supply voltage or doesn't have something to do with the software settings?
I'm not too familiar with solidoodles but does it show the temperature reading from the thermistor? What firmware are you running do you know?
Thank you for trying to help. I figured it out. I ran an extra fan directly to the power supply and it fixed it