Using Larger Nozzles, Z-axis + wiring woes.

Discussion in 'Calibration, Help, and Troubleshooting' started by Tony Glancy, Aug 15, 2016.

  1. Tony Glancy

    Tony Glancy Member

    Joined:
    Aug 15, 2016
    Messages:
    4
    Likes Received:
    0
    Hi all, My first post. I'm trying to use use larger diameter nozzles for faster, low-accuracy builds.

    My problems are the that supplied heater block, pictured, does'nt fit. It protrudes too low, the IR sensor cannot bet set low enought, and the wiring is a mess.

    Does anybody know where I can find the setup info for using different nozzles?

    Thanks,

    Tony
     

    Attached Files:

  2. Stian Indal Haugseth

    Stian Indal Haugseth Well-Known Member

    Joined:
    Sep 11, 2015
    Messages:
    573
    Likes Received:
    95
    @Tony Glancy, I was assembling my first Volcano yesterday and after some thought it should not be much of a problem that it sticks out. Annoying, ugly and impractical yes.

    IR I can't help with.
     

Share This Page