V6 BigBox, Feeding new Filament after old?

Discussion in 'Calibration, Help, and Troubleshooting' started by Old_Tafr, Apr 16, 2019.

  1. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    721
    Likes Received:
    92
    I have as yet never managed to feed a new piece of filament through after a roll has run out, not without total disassembly of the V6, which is slow and tedious with heater and PT100 sensor to extract and re-calibration as nozzle at a different height etc.

    Can anyone share their technique for just feeding new filament through?

    This is an original BigBox with V6.
     

Share This Page