V6 Stopps heating

Discussion in 'E3D-v6 and Lite6' started by Ctx32, Jun 18, 2016.

  1. Ctx32

    Ctx32 Member

    Joined:
    Jun 18, 2016
    Messages:
    2
    Likes Received:
    0
    I need some help,
    Just installed the V6 into my Hictop printer, Updated and edited my firmware.
    The print starts, 1st layer is great the it sets for the next layer and the V6 heater turns off.
    You can see it on the LCD drop from 210 and just keeps dropping.
    Is this something in the firmware?
    I started the print over several times and get the samething everytime.
     
  2. Ctx32

    Ctx32 Member

    Joined:
    Jun 18, 2016
    Messages:
    2
    Likes Received:
    0
    I also forgot to mention.
    It turns the V6 off as soon as the Z steppers raise for the next layer.
     
  3. Jeroen

    Jeroen Member

    Joined:
    May 21, 2016
    Messages:
    10
    Likes Received:
    1
    Does the temperature setpoint remain at 210 degrees, or does that also drop?
     

Share This Page