Hi all, I have just received a V6 3mm Bowden. Before this i had a V5 3mm Bowden. I have just installed the hotend. I change the thermistor setting at marlin to 5 (instead of the -1 for the V5) and i get an error at the display of the printer: MINTEMP. If I change to -1 I get about 80 celsius degrees, and the room is at about 28 celsius degrees. I have double checked shortcircuits and everything is ok. I install again the old V5, set to -1 and the readings are ok, so the connections to the Megatronics are ok. Any idea? Faulty thermistor? Thanks in advance and best regards
ok, my fault I think I was connecting the thermistor at the thermocouple connector. I change and try. Sorry.