Velleman k8200 e3d v6 problem

Discussion in 'E3D-v6 and Lite6' started by Rraijjar, Apr 23, 2015.

  1. Rraijjar

    Rraijjar New Member

    Joined:
    Apr 23, 2015
    Messages:
    1
    Likes Received:
    0
    Well i have a problem with my newly installed e3d hotend on my velleman k8200. The thermistor works, if i keep my finger to the hotend the temperature will go up. But the heater cartridge for some reason does not work. Any idea how to fix that?

    Or is there something i need to update in the firmware?
     
  2. Hozza

    Hozza Member

    Joined:
    Apr 24, 2015
    Messages:
    5
    Likes Received:
    0
    Have you got access to a multimeter, if so test the resistance over the heater plus you could test you're getting voltage to the heater also.
     

Share This Page