Warp control - part cooling method

Discussion in 'Calibration, Help, and Troubleshooting' started by Bluemalu, Jun 30, 2016.

  1. Bluemalu

    Bluemalu Well-Known Member

    Joined:
    Mar 17, 2014
    Messages:
    95
    Likes Received:
    6
    What method is the preferred one for setting the part cooling fans?

    (1) As per manufacturers ie for Edge not for 1st layer then 50%
    (2) As per experience from Benchy and slowly increase fan speed as layers increase.

    What would the effects on the warping be with the slow cool method for the first few layers ramping up the fans vs straight onto final power %.

    Fairly confident the answer will be a bit of both but when working in isolation it's nice to know your not thinking too far outside the 4th percentile.
     
  2. mike01hu

    mike01hu Well-Known Member

    Joined:
    Apr 22, 2014
    Messages:
    957
    Likes Received:
    166
    I use 0 for L1 then progress to 50% over 10 layers.
     

Share This Page