way to hard to get hotend into into dual carriage.

Discussion in 'Calibration, Help, and Troubleshooting' started by KNM3D, Apr 1, 2016.

  1. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    214
    Likes Received:
    8
    why is it so damn hard?
     
    #1 KNM3D, Apr 1, 2016
  2. Henry feldman

    Henry feldman Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    969
    Likes Received:
    391
    There is another thread on sanding/etc to get the hot end into place...
     
    #2 Henry feldman, Apr 1, 2016
  3. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    214
    Likes Received:
    8
    I love these types of replies,
    i kind of figured that, but was not able to find it.
    you wouldn't by chance have the link to it would you? lol
     
    #3 KNM3D, Apr 1, 2016
  4. Henry feldman

    Henry feldman Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    969
    Likes Received:
    391
    sorry, was hard to do on a phone. I searched for dremel: here it is
     
    #4 Henry feldman, Apr 1, 2016
  5. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    214
    Likes Received:
    8
    I was half messing with you.
    thankyou very much

    on the hotend heatsinks installing them should they fit but be snug, or slide in and out smoothly with little resistance?
     
    #5 KNM3D, Apr 1, 2016
  6. Kanedias

    Kanedias Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    408
    Likes Received:
    124
    Slide in is fine, the important thing is that its not so loose that there can be any movement.
     
    #6 Kanedias, Apr 1, 2016
  7. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    214
    Likes Received:
    8
    are there anymore m3 lock washers hiding somewhere im short by a lot.
     
    #7 KNM3D, Apr 1, 2016
  8. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    214
    Likes Received:
    8
    found the lock washers

    now where do I find more
    m3 brass stud inserts that go into the acrylic im
    im 7 short for the m3
    im 3 short for the m2.5

    have any idea where these may be hiding?
     
    #8 KNM3D, Apr 2, 2016
(You must log in or sign up to post here.)

Share This Page