What bits were left after the build was finished? :-)

Discussion in 'Build Help' started by Old_Tafr, Apr 1, 2016.

  1. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    561
    Likes Received:
    75
    I have not commissioned the Pi and the Pi Cam yet, or put the sides on, or put all the base nut traps in either... waited until things worked as the base assembly is a right pain.

    But I have a some M3 10, 15, 18, 20, 30 and 35 mm quite a few M4 of lengths from 18 to 25, M3 & M4 half nuts, grub screws microbarbs etc.

    Nice to be given extras as it's easy to lose the odd item, but just wondered what other people found they have in case there is something at the end of the build that I have missed !
     
  2. Rob Heinzonly

    Rob Heinzonly Well-Known Member

    Joined:
    Sep 20, 2015
    Messages:
    362
    Likes Received:
    125
    I have roughly the same amount of screws, nuts, grub screws and microbarbs lying around, and my printer didn't fall apart yet. So I guess this should be normal ;)
     
  3. Pierce

    Pierce Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    249
    Likes Received:
    67
    They mentioned you get what you need plus 10% extra for all nuts bolts and screws so expect to have some left!
     
  4. Falc.be

    Falc.be Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    244
    Likes Received:
    38
    Most of the m3x10 screws because I used the m3x12 ones on most cases, had to buy extra by the time i found out

    For the rest about the same + the printed parts I broke, reprinted them on the ultimaker
     
  5. Stefan

    Stefan Well-Known Member

    Joined:
    Feb 17, 2016
    Messages:
    323
    Likes Received:
    43
    Me too, some screws, washers, nuts and a Extruder Idler arm thing.
     

Share This Page