What do I need for the Ultimaker v1?

Discussion in 'E3D-v6 and Lite6' started by chaosbanane, Jun 23, 2014.

  1. chaosbanane

    chaosbanane New Member

    Joined:
    Jun 23, 2014
    Messages:
    1
    Likes Received:
    0
    Hi there

    I searched around quiet a while and I would like to ensure what I need to get the v6 Hot End working on my Ultimaker 1.

    I planed to purchase the "v6 HotEnd Full Kit - 3.00mm Bowden" version.

    This version comes with a "12v 40W Heater Cartridge". From what I read so far, I need a "24v 40w Heater Cartridge" to hook it up to the UM1 mainboard. (correct?)

    • Is it possible to switch this cable when I order the full kit?
      Can I hook up the heater to the UM stock board in the same way like the stock hot end is connected?

    The other question directs the temperatur measurement. The set comes with an "100K Semitec NTC thermistor" and the corresponding wire.

    • Can I hook this thermistor to the stock UM1 thermocoupler?
      Will the wiring to the UM stock board stay the same?

    Thank you for clarification!

    UPDATE: I switched to the Ultimaker forum -> http://umforum.ultimaker.com/index.php? ... r/?p=57411
     
  2. Dr-Idee

    Dr-Idee New Member

    Joined:
    Jul 15, 2014
    Messages:
    1
    Likes Received:
    0

Share This Page