What Happens If It All Goes Wrong Tomorrow?

Discussion in 'BigBox General Chat' started by Jasons_BigBox, Nov 7, 2016.

  1. Jasons_BigBox

    Jasons_BigBox Well-Known Member

    Joined:
    Mar 25, 2016
    Messages:
    232
    Likes Received:
    69
    Spoon Unit and markoaurelije like this.
  2. Jasons_BigBox

    Jasons_BigBox Well-Known Member

    Joined:
    Mar 25, 2016
    Messages:
    232
    Likes Received:
    69
    This seemed funny at the time..............

    So did printing a bigger version yesterday for a friend. It took it to until 9 o'clock this morning to complete. Timelapse here:

     
  3. Falc.be

    Falc.be Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    243
    Likes Received:
    38
    I honestly believe the world is gonna bleed
     
  4. Tom De Bie

    Tom De Bie Well-Known Member

    Joined:
    May 7, 2016
    Messages:
    191
    Likes Received:
    33
    Perfect! A fine example of how well the BB can print if you set your mind to it ;)
     
    PsyVision likes this.
  5. Jasons_BigBox

    Jasons_BigBox Well-Known Member

    Joined:
    Mar 25, 2016
    Messages:
    232
    Likes Received:
    69
    It came out pretty nicely. The light grey PLA does print quite easily. It's a bit odd in that under some lights it appears perfect then you pick it up again later and see the imperfections. Still good though.
    I printed it tilted back to avoid having supports on the faces. I would have liked to print it totally hollow as only a couple of flats would have needed support inside but I couldn't see how to add them in S3D. I suppose I could have removed the bottom face and thickened the others.

    Falc.be we can only hope that the reality of government politics will pull back on some of his policies. Think positive thoughts!
     

Share This Page