Where or how do I make Assembly Manual changes?

Discussion in 'General' started by gearmesh, Jun 5, 2016.

  1. gearmesh

    gearmesh Well-Known Member

    Joined:
    Feb 21, 2016
    Messages:
    162
    Likes Received:
    13
    I am not sure where one posts suggestions to changes in the assembly manual for the BigBox?
    Something I read yesterday in step 23.

    Position the printer onto it's left side. Before tipping on its left side SECURE THE X-CARRIAGE or MOVE IT FULLY LEFT TO AVOID IT CRASHING INTO THE STOP.

    If someone were following the step in sequential order, they may miss the warning, It would be better if the sentences were switched in position:

    MOVE THE X-CARRIAGE FULLY LEFT TO AVOID IT CRASHING INTO THE STOP then position the printer onto it's left side.

    I didn't miss it but I bet some builders did. Maybe even write the warnings in Red to prevent a catastrophe.
     
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    444
    Likes Received:
    89
    First step is to request an account, then it will be approved and you can make changes as needed
     

Share This Page