Which extruder to buy - bowden or direct for PRUSA i3 MK2S?

Discussion in 'E3D-v6 and Lite6' started by Plastic Man, Oct 5, 2017.

  1. Plastic Man

    Plastic Man New Member

    Joined:
    Oct 5, 2017
    Messages:
    1
    Likes Received:
    0
    The original extruder got jammed. I want to buy a full replacement so I can also have some spare parts.

    Which one should I purchase?

    I am running e3d v6 1.75mm.

    Thanks,

    Plastic Man
     
  2. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    561
    Likes Received:
    75
    It would be good to see a picture and info on all the heat sinks available, I have several some I think sent in error. They are difficult to identify and those already mounted on the BigBox impossible to see to compare with.

    I also find a few sites like this one...

    http://www.matterhackers.com/

    easier to negotiate than the E3D one (even the new site)
     

Share This Page