Wipe V6 and Volcano

Discussion in 'Calibration, Help, and Troubleshooting' started by Mick Bishop, Dec 14, 2020.

  1. Mick Bishop

    Mick Bishop Member

    Joined:
    Nov 29, 2020
    Messages:
    3
    Likes Received:
    0
    Hi been looking through forums and am trying to understand how to call different macros depending on the tool in use.I have two V6 and the Volcano which is 10mm lower. I am trying to call different prime macros at toolchange for my brushes (my wipe stand has one 6mm higher than the other). I am using Slicer 2.3 and Duet wifi 2.05.1 Apologies if this is a dumb question.

    Update realised that it is as simple as having separate volcano filament with different m98 wipe in start gcode
     
    #1 Mick Bishop, Dec 14, 2020
    Last edited: Dec 15, 2020

Share This Page