X axis not auto-homeing

Discussion in 'Calibration, Help, and Troubleshooting' started by Steven, May 15, 2016.

Tags:
  1. Steven

    Steven Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    211
    Likes Received:
    19
    If the dual head is in the middle of the bed, when I select auto-home, the Y axis will move the head to home, Z axis will simultaneously move up and the auto-level sensor will see it and then the bed goes to 4mm (as I expect it would). BUT the Rumba thinks the X-axis is where ever the head is during power up!

    IF i move the head all the way to the left, select auto-home, then the head correctly auto-homes, albeit the home goes to 5,5,4mm. (x,y,z)

    Shouldn't the X axis ALSO move to home no matter where it is ?
     
  2. Rob Heinzonly

    Rob Heinzonly Well-Known Member

    Joined:
    Sep 20, 2015
    Messages:
    448
    Likes Received:
    174
    Did you check the connector of the X-axis endstop ?
     
  3. Steven

    Steven Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    211
    Likes Received:
    19
    yup, buy x stop wasnt plugged in all the way.
    fixed now.
     

Share This Page