SOLVED X-Carriage Design Changed?

Discussion in 'Build Help' started by Jasons_BigBox, Jul 14, 2016.

  1. Jasons_BigBox

    Jasons_BigBox Well-Known Member

    Joined:
    Mar 25, 2016
    Messages:
    232
    Likes Received:
    69
    Morning all!

    I'm just beginning my build and I noticed that my X-Carriage printed part is a little different to that in the manual:

    X-Carriage.jpg

    It looks like that area is sprung to tension the belt but that means that the 'D' shaped piece on the left can't be fitted to adjust the belt tension.

    Any recommendations?

    I'm going to try to document my build as its a 1.1 Titan Hybrid, hopefully I'll remember to keep taking photos!


    Thanks for your help,


    Jason
     
  2. Sarah Nicholson

    Sarah Nicholson Well-Known Member

    Joined:
    Dec 20, 2015
    Messages:
    319
    Likes Received:
    114
    It's just support material left over, you should be able to easily pull it out with pliers. I had the same thing on my X carriage.
     
  3. Jasons_BigBox

    Jasons_BigBox Well-Known Member

    Joined:
    Mar 25, 2016
    Messages:
    232
    Likes Received:
    69
    Great, Thanks Sarah!
     
  4. Mark_T

    Mark_T Well-Known Member

    Joined:
    Apr 23, 2016
    Messages:
    239
    Likes Received:
    34
    Mine is like that as well, a couple of other pieces have more obvious support material left in place as well.

    Not an issue of course, just takes a moment to realize that it is support and not a part of the design :)
     

Share This Page