Y-Axis Motor Cable Length

Discussion in 'Build Help' started by ldaponte, Aug 16, 2016.

  1. ldaponte

    ldaponte Well-Known Member

    Joined:
    Jul 22, 2016
    Messages:
    74
    Likes Received:
    6
    Building the BB 1.1 Dual Titan Hybrid as shipped from E3D. I'm at the point where I prepare the y-axis motor cable that calls for one 1000mm motor cable and a 800mm sleeve but I only have one motor cable left to install and its 1700mm and I have one 800mm sleeve and one 1500mm sleeve remaining. The x-axis cable is installed and both extruder motor cables are installed. Have been turning boxes upside down. Anyone else have this issue? I suppose I could just use the longer cable for the y-axis but feel like I did something wrong (wouldn't be the first time). The only 1000mm motor cable I have I used on the bowden titan motor cable on the rear of the BB.

    -Larry
     

Share This Page