Z axis homing just crashes on E3D ToolChanger

Discussion in 'Troubleshooting' started by Ted King, May 31, 2021.

  1. Ted King

    Ted King New Member

    Joined:
    May 31, 2021
    Messages:
    1
    Likes Received:
    0
    Has anyone gotten z axis homing to work on E3D ToolChanger with Duet 2, rrf3. I’ve tried everything I can think of, the wiring is correct, the Duet board Z led goes out when the Z switch is pressed. Z moves work fine. X & Y homed first, then G30 just crashes into the z switch and screams and I have to emergency stop. I have found out that rrf3 made major changes in how z homing and probing works, but am unable to find any corresponding updated g-code, just some cryptic words about separating homing and probing. E3D support has bee useless. Any help appreciated.
     
  2. Greg Holloway

    Greg Holloway Administrator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    1,020
    Likes Received:
    631

Share This Page