Z crash.

Discussion in 'Calibration, Help, and Troubleshooting' started by kevin, Nov 21, 2016.

  1. kevin

    kevin Member

    Joined:
    Nov 15, 2016
    Messages:
    2
    Likes Received:
    1
    When I auto home my printer goes home in x and y but crashes in z because it dosn´t make a safe homing. the safe homing worked before i flashed a new firmware. Im looking in it right now and im having a hard time figuring out the problem or the parts i need to change. Do someone have any clue what to do for fixing it?
     
  2. mike01hu

    mike01hu Well-Known Member

    Joined:
    Apr 22, 2014
    Messages:
    957
    Likes Received:
    166
    Is the IR detector over the bed when the Z movement is happening? If not, you need to check which version of the firmware you have loaded as there are offset settings that account for how you have configured your printer.

    There is a lot of posts on this issue if you want to search.
     
    kevin likes this.
  3. Falc.be

    Falc.be Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    244
    Likes Received:
    38
    Sounds like you flashed a 1.0 firmware in a 1.1 machine
     
    kevin likes this.
  4. kevin

    kevin Member

    Joined:
    Nov 15, 2016
    Messages:
    2
    Likes Received:
    1
    Yeas I hade the v1.0 and flashed in the v 1.1 and now its perfect... thank you!
     
    mike01hu likes this.

Share This Page