Z-Offset For Duals

Discussion in 'BigBox General Chat' started by Syko_Symatic, Apr 12, 2016.

  1. Syko_Symatic

    Syko_Symatic Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    348
    Likes Received:
    78
    Does this exist yet? I noticed there is a Bed Z option in the new firmware but I am yet to figure out what this is. Is it difficult to implement for the dual setup? Surely it is literally what it is and offset on a number?
     

Share This Page